Lambda Machine Works Machining · Industrial Repair

The work

Heavy repair work, handled across the metroplex

The work we take on for Fort Worth-area facilities leans heavy: process and water facilities, manufacturing and distribution operations, and the pumps, gearboxes, and shafts that keep them moving. A full-length vertical turbine pump overhaul — column sections, bowls, and discharge head inspected end to end — is typical of the repair bench, and long shaft work is everyday machining here, not a special case.

The shop is in Frisco, on the north side of the metroplex — but a repair job doesn't start with a drive. Send photos of the part and its nameplate first: for repairs, we tear down and measure, then quote before any machining starts, and pickup and delivery is available for repair jobs across Dallas–Fort Worth. When rebuilding isn't sound — a shaft too far gone, a part the OEM no longer stocks — we machine a complete replacement in-house, including replacement parts reverse engineered from the failed component.

Work we take on for Fort Worth facilities

  • Pump overhauls — vertical turbine, centrifugal, split-case, and end-suction units rebuilt to spec
  • Gearbox rebuilds with the critical machining done in-house, backlash set to spec
  • Long shaft rebuilding — journals and seal surfaces restored, straightness and runout checked on the lathe
  • Replacement parts for obsolete or imported equipment, made to fit the machine they came off of
  • Build-up welding and finish machining that put worn components back in service
Long vertical turbine pump column laid out on stands during overhaul at a Frisco machine shop
Vertical turbine pump overhaul — laid out on stands, inspected end to end

How it works

How a Fort Worth repair job runs

Fort Worth, Arlington, and Haltom City are all inside the shop's Dallas–Fort Worth service area. The process is the same wherever the part starts:

Step 1

Send the part or print

Call or email a photo, a drawing, or the failed component itself. For repairs, a few photos usually get the conversation started.

Step 2

Inspection & honest quote

We tear down and measure, then quote the repair before any machining starts. No surprises after the fact.

Step 3

Machine & rebuild

Journals rebuilt, bores restored, new bearings and seals fitted — every critical dimension checked on the bench.

Step 4

Back in your hands

Pickup at the shop or delivery across DFW, with the old parts returned so you can see exactly what was done.

Fort Worth — common questions

Do you serve Arlington and Haltom City as well as Fort Worth?

Yes. Lambda Machine Works is based in Frisco and serves all of Dallas-Fort Worth, including Fort Worth, Arlington, and Haltom City. Pickup and delivery is available for repair jobs across the metroplex.

Can you overhaul a vertical turbine pump?

Yes. Pump repair and rebuilding is core work at the shop — teardown, inspection, and rebuilding with seals, bearings, and wear rings replaced and impellers repaired or machined new. A full-length vertical turbine pump overhaul, with column sections, bowls, and discharge head inspected end to end, is shown on the Our Work page.

How do we get a quote from Fort Worth?

Call (214) 662-7171, email lambdamachineworks@gmail.com, or use the quote form on the contact page. Send a photo of the part, a drawing, or the failed component itself. For repairs, the shop tears down and measures first, then quotes the repair before any machining starts.

Closer to the Dallas side? See machine shop & industrial repair in Dallas. Breakdown on the west side? See emergency industrial repair.

Pump down in Fort Worth?

Send us a photo of the part and tell us what it came off of. We'll tell you straight whether it can be rebuilt — and what it will cost.

Request a Quote ☎ Call (214) 662-7171